Backloop Handplant
Kiteloop with a back loop in which you simultaneously pull the hand through the water, is a trick for the audience: stunning, stylish and just something else. It is seen in many videos. We’ll tell you now how it works.
REQUIREMENTS
Back loops should not be a problem for you as well as kite loops. The trick works best if you also have a pleasant pressure in the kite. We suggest here a rather faster kite, a criterion now meet almost all kites on the market.
PREPARATION
Drive at normal speed (not too slow). The speed you can then increase again with time to pull the hand through the water longer can. If you have a sliding stopper, use it. If not, grab the back hand about ten inches from the depowerloop (depending on the kite). Fly the kite high up.
THE TRICK
Take your front hand on the bar and sit down at a slow back loop. Experiments as early as possible, the board up and the free hand to get it into the water. Throw your body a little bit more back than you would otherwise do with a back loop. As you pull the hand through the water, fly your kite at the zenith slowly backwards and carries you on a constant level. Be sure to depower, not, otherwise you will land soon in the water. When the kite is a bit behind the zenith, it is time to make the Kiteloop. Hit the bar and loop the kite through the top rear and as tight as possible. The Kiteloop will pull you up a piece, so you can finish your back loop and have enough height to get the board back under your feet.
TROUBLESHOOTING
It is important to keep the kite high up and looping the kite at the right time. If you aren’t coming out of the water after the kiteloop, then you may loop the kite to early. If the kiteloop should end in a violent pull, then you’re looping either too early or not tight enough.
